Leadshine’s drives with Ethernet/IP communication interface conform to CiA 301 application layer and CiA 402 device profile for drives and motion control. Connected in an EtherNet network, two or more drives can be set at the same physical address, and the EtherNet controller will automatically set the slave IDs. The communication cycle time is up to 250 µs (default). The terminator resistor switch is not required for EtherNet drive. Currently, Leadshine can provide EtherNet drive models such as dual-axis EtherNet/IP stepper drive, and single-axis EtherNet/IP stepper drive are also available.
INFORMASI PRODUK
Stepper Drives
| Model |
Command Source
|
Operation Voltage
(VDC) |
Output Current
(A, Peak) |
Logical Voltage
(VDC) |
# of Inputs
|
# of Outputs
|
| 2EM3EIP-522 | EtherNet/IP | 20-50 | 2.2 | 12-24 | 2*4 | 2*2 |
| 2EM3EIP-556 | EtherNet/IP | 20-50 | 5.6 | 12-24 | 2*4 | 2*2 |
| 2EM3EIP-870 | EtherNet/IP | 20-80 | 7 | 12-24 | 2*4 | 2*2 |
2EM3EIP series drives support operating modes: Profile Position (PP), Profile Velocity (PV), and Homing (HM). The products can be matched with most of master station such as Beckhoff, Omron, Keyence, Panasonic etc.
Closed Loop Stepper Drives
| Model |
Command Source
|
Operation Voltage
(VDC) |
Output Current
(A, Peak) |
Input Frequency
(KHz, Max.) |
Logical Voltage
(VDC) |
# of Inputs
|
# of Outputs
|
| 2CS3EIP-D503 | EtherNet/IP | 20-50 | 2.2 | 10 | 12-24 | 2*4 | 2*2 |
| 2CS3EIP-D503 | EtherNet/IP | 20-50 | 7.0 | 10 | 12-24 | 2*4 | 2*2 |
2CS3EIP series drives support operating modes: Profile Position (PP), Profile Velocity (PV), and Homing (HM). The products can be matched with most of master station such as Beckhoff, Omron, Keyence, Panasonic etc.
